| |||||||||||||||||||||||||||||||||
Description: Programmable 1 channel PCB board with 2M USB Cable and 4" wires soldered to BLUE momentary push button. Button is lighted and is programmable. This device has 1 inputs and 1 outputs. The 1 inputs can be programmed to emulate keycodes, mouse buttons and joystick buttons or can be read via software. The Output can be used as generic control such as to drive a LED. See the 890672 Delcom Setup Utility below to setup the device. Device also supports the DelcomDLL and all generation 2 commands. Supports all Major operating systems (32 and 64 bit). Simple plug and play USB compliant device. Uses the systems USB HID driver, no drivers to load. Unique serial number in each device. Self Powered from the USB port. PCB Dimensions: 1.0" by 0.45", PCB used 705005 2M USB Cable included. Wire Colors: (Wire length 4") Black - Common (Ground) - Used for both input and output. Grey - Input 1 (Switch) - Short to Ground to activate. Yellow - Output 1 (LED) - Goes high (+5VDC*) when active. *Output current depends on internal resistor used. Contact us for more info. DECLARATION OF CONFORMITY
|